This creation is not very complicated, follow the instructions below to successfully complete the assembly.

To start, cut 2 pieces of chain while keeping 6 ball links. Then take the brass wire and form a wrapped loop by placing one of the chains before wrapping the wire. Cut the brass wire cleanly and, if necessary, slightly flatten the brass wire to prevent it from snagging.

Thread the 3 Lapis Lazuli beads onto the brass wire, then form a wrapped loop symmetrically. Be sure to place the other chain before wrapping the brass wire!

Your first row of the bracelet is thus assembled!

Now, thread a crimp bead onto the silk thread, pass the needle through the last link of the chain, then back through the crimp bead. Bring it towards the last link and gently flatten it. Make a double knot with the silk threads at the edge of the crimp bead, then cut the excess thread flush.

To secure the knot, you can place a small dot of glue.

Now thread the mother-of-pearl beads, about 22 beads. Pass through the second hole of the Lapis Lazuli beads, then continue threading the mother-of-pearl beads symmetrically.

Now thread a crimp bead, pass through the last link of the chain, then back through the crimp bead. Gently flatten it, ensuring there is not too much tension between the beads. Your threading should remain flexible!

Make a knot between the last mother-of-pearl bead and the crimp bead, then secure it with a small dot of glue.

To finish, connect the clasp and the extension chain (about 3cm) with 3mm rings.

Your jewel is finished!

Beautiful creation!