|
An elegant touch to your wrist... This bracelet combines 24K gold and the iridescent shades of black mother-of-pearl. A creation full of finesse, very easy to make and that you can personalize with the stones of your choice!
|
|---|
| For this project you will need: | ||||
|
|
||||
| Tools to use: | ||||
|
|
||||
| Step 1: | ||||
|
|
This bracelet uses classic assembly techniques. To start, glue the stone into the cabochon setting. Apply a small dab of glue in the center of the setting, then gently place the stone. Wait for complete drying before continuing. Next, measure your wrist and subtract the value of the pendant, about 2.5cm. Take the measurement snugly on the wrist; the value of the jump rings and the lobster clasp will add the necessary ease for comfort. Divide the obtained measurement in half, cut the 2 chains to size. Gently separate the chevron chain by opening the chevron links using 2 flat pliers like for a ring. Then close the chevron link so it returns to its original position. Connect the chains to the pendant with 3mm rings. Be careful with the direction of the chain. Look closely at the photo below.
To finish, place the lobster clasp and the extension chain at the ends of the chains with 3mm rings. And there you go! Beautiful creation! |
|||
To be reserved alone or with friends!
Join Perles Corner to discover our new products, exclusive tutorials, and many other surprises... and receive your voucher by email!
an 8mm cabochon connector pendant
3mm rings
