Abalone Beach Bracelet

Fall for our new jewel made of a superb Abalone mother-of-pearl bead with multiple reflections.

To highlight the bead, we paired it with two chains. One with small golden nuggets and one beaded with Amazonite to showcase the turquoise hue of the bead.

A simple multi-strand bracelet to make where the two chains naturally blend on the wrist to add elegance and a lot of delicacy.

An ideal tutorial for beginners or experienced creators.

Beautiful creation!

For this creation you will need:
of the amazonite rosary chain Gold-plated with 24K gold of the nugget chain Gold-plated with 24K gold a mother-of-pearl Abalone bead, abalone shell an eye pin Gold-plated with 24K gold metal beads Gold-plated with 24K gold 4mm rings Gold-plated with 24K gold of the extension chain Gold-plated with 24K gold a lobster clasp Gold-plated with 24K gold mounted pearls Gold-plated with 24K gold

The tools to use:
jewelry creation pliers (round, flat, and cutting)

The assembly:

This creation is quite simple to make, follow the instructions below to faithfully reproduce this model.

To start, mount the pearl on a head pin, surrounded by 2 metal pearls. Form a nice loop (of the same size and in the same axisas the one already present on the pin).

Now, measure the length of the pearl you just mounted (measurement taken with the loops) These pearls are all unique, the size and shape may vary, so it is very important to measure each assembly before cutting the chains. Measure your wrist circumference and then subtract the measurement of the pearl assembly.

Do not add any value to your measurement, the clasp and the extension chain will add the necessary ease for the comfort of the jewelry. If you prefer a bracelet that fits snugly on the wrist, you can remove a little from the measurement.

Divide the obtained measurement by 2. This gives you the length of the chains to cut.

Cut 2 pieces of nugget chain and 2 pieces of rosary chain of the same size.

Connect the chains directly to the loops located on each side of the pearl. Do not add rings!

Now, open a 4mm ring and connect the clasp to the 2 chains on one side of the bracelet. On the other side, connect a 3cm piece of extension chain to the 2 chains with a 4mm ring.

To finish, open a 4mm ring, insert 3 mounted pearls, and connect the ring to the end of the extension chain.