0.7mm rigid brass wire
 4mm and 6mm cushion beads
 2mm cube beads
 A round-nose pliers
 A flat pliers

To start, measure your wrist and adjust the details below to your measurement. Here we are starting with a wrist of 17cm. 

These bracelets should not be too tight on the wrist; they should have a loose fall. This way, the bangles will mix, the beads will move, and create movement.

Hold the brass wire with the round-nose pliers about 2cm from the end. Position the round-nose pliers at the point that will correspond to a loop of about 5/6mm in diameter. Indeed, your pliers are finer at the tip and widen as you go up. You will adjust the position according to the size of the desired loop.

Fold the wire around the pliers to form a loop, then hold the end of the wire with the flat pliers and wrap the wire at the bottom of the loop in one turn. 

Cut the excess flush.

Be careful to hold your pliers gently, too much pressure will tend to mark the wire!

Then thread the metal and cushion beads...

Measure the brass wire and cut it to 3cm from your wrist measurement.

At the end of the wire, fold the wire back 1cm from the edge to double it. Make sure to fold it well so that it is perfectly against the wire of the bracelet. 

Then, using the round-nose pliers, form a hook with the doubled wires. (Look closely at the photo below to follow the path of the wire).

Gently shape the wires to fit the wrist.

Make as many bracelets as you want... for a nice effect you can stack 5 or more!!!!

And there you go! Beautiful creation!