Circle pendants
 Moon horn pendants
 a 6mm set connector
 Textured connectors
 Natural pearls
 3mm and 4mm rings
 Rosary chain and/or confetti
 0.4mm flexible brass wire
 Clasp

For the necklace with a crystal quartz stone floating in the circle:

Cut a brass wire of about 30cm, then wrap one end of the wire around the edge of the closed ring for 3 turns. Cut the excess wire and tuck in the edge for a nice finish. Then insert a small bead before making 3 turns around the edge of the ring. Your bead should be placed on the outside of the circle.

Pull the thread towards the center of the circle, then thread a crystal quartz bead and position it at the center of the circle.

Wrap the thread around the bead for 3 turns to secure it before going back to make 3 turns around the edge of the ring.

Thread a small bead again before making 3 turns around the edge of the ring.

Then place small beads in the desired spots on the outer part of the ring with thread.

For a more dynamic look, position the small beads randomly. A faux disorganization! Do not place them symmetrically or too regularly.

To finish, connect the moon horn with a 4mm ring and at the top of the circle, the textured connector with a 4mm ring.

Cut your chain to the right length, then place the clasp and the extension chain at the ends.

Connect your pendant suspension to the chain with a 4mm ring.

For the rosary chain necklace:

Assemble the different elements with 4mm rings. The moon horn at the bottom, the setting, the circle pendant, and then the textured connector.

Cut 20cm of rosary chain and 2 pieces of simple link chains to the desired length. Connect the 2 chains to the rosary with 3mm rings (or 3mm oval ones).

To finish, place the clasp and the extension chain at the ends of the chains, then connect the pendant suspension to the chain with a 4mm ring.

And there you go! Beautiful creation!