Natural bead wires
 0.4mm brass wire
 20mm hoops
 Pendulums

This creation is quite simple, don't try to be too regular, you will see that the beads will naturally place themselves on the edge. In this type of creation with ethnic inspirations, it is the slightly irregular 'handmade' aspect that gives all the charm and makes your creation more lively.

To start, cut a brass wire of about 30cm. (Be careful not to take too little wire as no connection is possible, nor too long at the risk of tangling the wire.)

Wrap one end of the wire around the hoop making 3 tight turns. Then cut the excess wire flush.

With flat pliers, flatten the edge of the previously cut wire towards the hoop to prevent it from snagging. 

Start working with the beads...

Thread a bead, place it on the outer edge of the hoop, and then bring the wire inside the hoop. Your bead will naturally get locked in place.

Bring the wire outward and then thread another bead. Place it at the edge and then wrap the wire around the hoop.

Continue like this until you place 9 beads...

In the center, proceed as with the beads but this time with a pendant. Wrap the wire around the hoop and then continue symmetrically with the 9 remaining beads.

To finish, wrap the wire tightly around 3 turns at the edge of the last bead.

Cut the wire flush and then flatten it neatly.

And there you go! Beautiful creation!