Natural stone beads
 Soft brass wire 0.4mm
Chain
Clasps and rings if needed

To start, cut a brass wire of about 20cm. If you are working with a drilled stone, thread the wire through the hole. Leave about 3cm of wire sticking out from the bead.

Then wrap the wire around the stone making 3 turns. Tighten the wire well.

Wrap the wire around the starting wire to secure it, make 2/3 turns, then cut the wire flush.

Then, using round-nose pliers, make a loop on the starting wire. Then wrap the wire around about 3 times to create a wrapped loop.

Cut the wire flush.

You can make these necklaces with drilled stones or pointed, raw crystals... For a non-drilled stone, you will need to wrap it well and tighten the wire to secure the stone.

Now all you have to do is mount your stone on a chain!

And there you go! Beautiful creation!