To start, cut 2 pieces of 1mm wire about 30cm each and 2 Linhasita wires about 50/60cm.

If you take a pendant with the ring perpendicular (like for the talisman connector) you won't need to place rings. For connectors with holes, place 4mm rings.

Then thread a 1mm wire and a Linhasita wire through the ring, fold the 1mm wire in half and bring it to the center to become the warp thread. The Linhasita wire will allow you to make knots on the warp thread.

Make the knots as explained in the video, with and without beads.

To finish, place the bracelet in its final position and then make a sliding knot with a new thread.

Make knots at the ends of the warp threads and then cut the excess.

Beautiful creations ;-)