Tie the nylon thread on the set Zircon connector ring. Make several knots to ensure that the thread does not come undone. Cut the excess thread to about 3mm from the knots.

Now thread 4 size 11/0 seed beads (green), one flower bead, one size 11/0 seed bead (purple), and one size 15/0 seed bead (salmon).

Pass the thread through all the beads except the size 15/0 seed bead (salmon). This one will be used to block the threading. 

Pass the thread through the ring of the connector and then pass through the first green bead.

Now, thread 3 size 11/0 seed beads (green), one flower bead, a size 11/0 seed bead (purple) and a size 15/0 seed bead (salmon).

Pass through all the beads except the small salmon bead as before.

You have just assembled a first duo of flowers.

Now pass through the ring of the set connector. 

Go back through the previous steps to assemble the other flower stems. In total, you need to assemble 8 flowers to get a nice cluster of flowers.

To finalize and secure the assembly, make several knots on the ring of the connector, being careful not to trap the thread in the flower petals or beads!

Between each assembly, be sure to pass through the ring of the set connector. This way, your cluster will form a nice ball.

To finish, gently open the ring of the sleeper and then insert the top ring of the set connector.

Go back through all the steps for the second loop.

Your jewel is finished!

Beautiful creation!

Find all the supplies to make this jewel at the bottom of the page.