Nacre Bracelet Wrapping

✨ Wrap Bracelet in Mother-of-Pearl – The chic and easy DIY to adopt! ✨

Want a piece of jewelry that is both trendy, bright, and ultra-simple to make? Discover our new tutorial to create a wrap bracelet around mother-of-pearl beads. A technique accessible to all, for a modern and refined result.

Thanks to the wrapping method, gently wrap a thread around the beads to form an elegant bracelet that will enhance your wrist. Ideal for beginners as well as DIY enthusiasts, this piece of jewelry will add a touch of freshness to your outfits.

Find all the step-by-step explanations below.

For this realization you need:
0.4mm brass wire 24K gold-plated a clasp 24K gold-plated 24K gold-plated extension chain mother-of-pearl beads

The tools to use:
pliers for jewelry creation

The assembly:

To start, cut a brass wire of about 20cm. (adjust this length during assembly to avoid losing wire)

At one end of the wire, form a loop, insert the clasp, then wrap the wire at the edge of the loop. You will thus form a wrapped loop that secures the clasp attachment.

Thread a bead and then form a loop at the edge of the bead. Do not cut the wire, wrap it around the bead. Do not try to wrap the wire too precisely, leave an organic side that will give more dynamics and relief to your assembly.

Then wrap the wire at the edge of the first loop for 2 turns to secure the wire. Cut the wire flush.

Take a new wire, form a loop, insert the loop from the previous assembly, then form the wrapped loop.

Insert a new bead, then form a wrapped loop and wrap the wire around the bead. Secure the assembly by wrapping the wire at the edge of the loop.

Continue like this until you reach the length of your wrist.

For the last bead, thread 3cm of extension chain through the last loop.