Mother-of-pearl beads 4mm
Mounted mother-of-pearl beads
 6x8mm mother-of-pearl cabochons
 Earring supports for 6x8mm cabochons
 3mm and 4mm rings
 0.7mm flexible brass wire
 UHU glue
 Jewelry creation pliers

To start, cut a piece of brass wire about 25cm long.

Divide the 4mm mother-of-pearl bead wire in 2, setting aside half for the other earring.

At one end of the brass wire, form a small wrapped loop as shown in the photo below.

Then thread 25 beads onto the brass wire.

Count 9 beads starting from the wrapped loop and then form a loop with the remaining 16 beads to create the bow loop.

Then twist the loop at the crossing of the wire to secure it.

Now form a ring at the edge of the loop. This will serve as a hook for the earring support.

Thread 16 beads onto the wire again and then form the 2nd loop symmetrically.

Twist the loop at the crossing point.

Now, thread the remaining 9 beads and bring them up to the edge of the loop.

To secure the beads, form a small wrapped loop as at the start of the assembly.

This way, you get a beautiful bow pendant. Give it a nice shape and life by creating curves and rounding the bead loops.

Next, open a 4mm ring and insert 5 small mounted beads, connect the ring to one of the created loops and then close it properly.

Do the same for the other loop.

Finally, glue the cabochons into the earring supports.

Then connect the earring supports with a 3mm ring at the top of the bow pendant.

Do the same for the other earring.

And there you go! Beautiful creation!