Linhasita thread for macramé Jewelry
 or waxed polyester thread

 a macramé mat
 T pins for macramé

To start, create your bracelet as you wish, adorned with beads, charms...

Then position it in a circle in its final shape.

Cut a new thread of about 30cm (size to adjust according to the number of knots to be made). Be careful, the shorter your thread is, the harder it will be to manipulate to form the knots.

Fold the thread in half and pass the loop under the crossing of your bracelet. Loop located towards the left.

Then pass the thread located on the bottom right over the thread on the top right. This will help to block it.

Then pass the thread that was on the top right over the crossed threads of your bracelet to enter the loop on the left.

Pull the threads on each side to tighten the knot. Be careful not to tighten the knot too much; your threads should be able to slide.

If needed, use the macramé pins planted in your mat to hold the bracelet in place.

Then to make a square knot, we will redo a knot on the other side. To prevent the knot from twisting, you will alternate the knots from one side to the other.

Pass the thread from the right under the crossed threads of the bracelet. 

Pass the thread located on the bottom left over the thread on top.

Then pass the thread that was on the top left over the bracelet to enter the loop on the right.

Tighten the knot...

Continue the knots as before, alternating sides. Once the loop on the left, then once the loop on the right...

Make as many knots as you wish.

To finish, cut the thread leaving 2mm and then burn the thread.

As soon as it starts to melt, press with your finger to stick the thread against the knots.

And there you go! Beautiful creation!