To start, connect the 8mm closed rings to the earring loop supports. To do this, open the ring located at the bottom of the loop and then insert the closed ring. Properly close the ring with flat pliers.

Now cut 3 nylon wires of about 20cm.

Connect the 3 wires to the closed ring with crimp beads. To do this, thread a crimp bead onto the first wire, pass the wire through the closed ring, then back through the crimp bead. Bring the crimp bead towards the edge of the ring and flatten it with the flat pliers. Be careful not to tighten the bead too close to the ring, the threads must be smooth!

Repeat the operation with the 2 other wires.

Now thread the beads of your choice.

Here we made threads of about 6 / 7cm, the longest with the mother-of-pearl beads. You can either make them all the same size or like us, playing with different lengths.

Hide the starting wires in 3 beads and then cut the excess wire.

To finish, thread a crimp bead onto the first wire, pass it through the ring, then back through the bead and the next 3. Pull on the wire to form the bead loop and bring the crimp bead towards the ring.

Flatten the crimp bead with flat pliers while ensuring the threading remains smooth.

Repeat this step with the 2 other wires.

Now go back through all the steps to make the other loop in symmetry.

Your jewel is finished!

Beautiful creation!