To start, thread the bead and the flower cup onto the pin, then thread the pendant. At the back of the pendant, form a simple loop. Be careful, this must be glued to the pendant to properly block the threading of bead/flower/pendant.

Now cut a chain to the length of your choice. Here we took a chain of about 45cm, so the pendant will fall on the sternum. 

Cut a piece of flexible brass wire and attach it to a link of the chain. Wrap the wire for 2 turns, then cut the excess flush.

For a nice finish, try to make discreet loops!

Now, thread 5 seed beads...

To block the beads, pass the brass wire through the other ring of the chain link. Your beads will thus be placed in a small curve around the ball of the chain.

Wrap the brass wire between the last bead and the link of the chain, make 2 turns, then cut the excess wire flush.

If the cut wire slightly exceeds, you can flatten it with flat pliers. 

Now continue this technique to dress your chain...

Here we placed 6 on the chain while being careful not to be completely symmetrical. This brings more life to the creation! We spaced the beads by one link and left the center of the chain free for the pendant's attachment.

Then connect the pendant to the center of the chain using the loop created previously.

To finish, attach the clasp and the extension chain (3cm) with 3mm rings.

Tip: To nicely embellish the extension chain, you can place a 4mm ring with 3 seed beads at the end of the chain. It's subtle and perfectly finishes the creation!

Your jewel is finished!

Beautiful creation!