a 35mm ring
 a wavy pendant
 a natural stone cabochon
 Miyuki seed beads 11/0
 copper wire
 a 6mm ring
 of the chain
 a 3mm ring

 pliers for jewelry creations 
 glue

To begin, place a small amount of glue under the cabochon, then position it on the corrugated pendant.

Wait for it to dry completely...

Meanwhile, cut a copper wire about 40cm long. Wrap it around the 35mm ring...

Next, thread the seed beads onto the wire over a length of approx. 15/20cm. If necessary, you can adjust the length during assembly.

Wrap the bead thread over the starting thread to hide it.
Hold the beads tightly together as you make the spirals, so that they sit correctly.
Make as many turns as you like, and add beads if necessary.

To finish, wrap the thread around the ring, then spread a little between the spirals. Trim the excess flush.

Cut a 75cm chain and connect the pendant and ring to a 6mm ring.
Pass the chain through the 6mm ring and close it with a 3mm ring.

Et Voilà! Beautiful creations!