This creation is not very complicated to make, just follow the instructions below to faithfully reproduce this model. Our video below shows you the essential assembly steps. Feel free to use the beads of your choice! 

Here we used Zirconium Oxide pearls for their brilliance and their rendering close to the transparency and color of snowflakes. 

To begin, cut a flexible brass wire approximately 60cm long. Be careful not to cut the wire too short, to avoid splices.

Wrap the brass wire around the closed ring and trim off any excess.

Now thread 3 beads onto the wire, then wrap the wire around the ring, forming a small curve with the beads. Tighten the wire to prevent the beads from moving.

Continue with the same method to place all the beads. With this ring size, you'll place a total of 24 beads, i.e. 8 modules of 3 beads each, to complete the ring.

Take the fancy faceted link chain, here 20cm, fold it in 2 to visualize the center link. Place the center link on the brass wire, then wrap the wire between 2 pearls to secure the chain to the ring. Wrap the wire between the bottom of the link and the ring to finish the attachment. Trim off excess wire.

Now cut the single-link chain into 2 pieces of 15cm, or longer depending on the length of necklace required. Connect the single-link chains to the ends of the fancy chain with connecting rings.

At the ends, place the clasp and extension chain (approx. 4cm) with connecting rings.

And that's it! Your creation is finished! I hope you like this tutorial and that it inspires you to use it with other beads, as a Christmas hanging decoration...

Beautiful creation!