To start, mount the beads on eye pins.

For the central assembly in amethyst, take a large eye pin, thread an oval bead and a faceted bead, a 6mm bead, and then an 8mm bead. Continue symmetrically with a 6mm bead, a faceted bead, and then an oval bead.

At the end of the pin, form a nice simple loop of the same size as the one already present on the pin.

Then make 6 assemblies with the mother-of-pearl beads.

On an eye pin, thread a tube bead, a mother-of-pearl bead, and a tube bead. Make a simple loop. Repeat this step with the remaining 5 pins.

Now, connect 3 mother-of-pearl assemblies together and then attach them to one side of the amethyst assembly. On the other side, connect the 3 mother-of-pearl assemblies. This gives you a chain of pearls.

Measure the previous assembly. Here we made a choker of about 40cm, adjust the measurement to your liking. 

Remove the value of the pearl assembly from your necklace size and then divide the result by 2. This gives you the measurement for each chain.

Cut 2 pieces of chain to the right length.

Connect the chains to the ends of the pearl assembly.

To finish, connect the clasp and about 4cm of extension chain to the ends of the chains with jump rings.

Your jewel is finished!

Beautiful creation!