2mm faceted Malachite beads
 An oval connector pendant
 From the Nugget Channel 
 10mm lobster clasp
 Extension chain
 0.4mm brass wire
 3mm jump rings

To begin, measure the size of your wrist. Then subtract 4cm corresponding to the size of the pendant, then 1cm . Divide the measurement into 2, which gives you the length of the 2 chains to be cut.

The value of the clasp and connecting rings will add to the bracelet's comfort value.

Cut an extension chain about 3cm long. This will make it easier to adjust the bracelet to your wrist.

Start assembly:

To begin, cut a flexible brass wire about 6cm long. 

Thread the wire through the hole in the connector, then wind the wire around the edge of the hole for 2 turns. Trim excess wire and flatten with flat-nose pliers if necessary.

Now string 12 Malachite beads... Adapt the number to the size of the slot.

Then thread the wire through the hole in the connector and wind it 2 turns between the bead and the edge of the slot.

Trim off any excess thread.

Now you can slightly deform the pendant to give it a curved shape that will follow your wrist.

Finally, connect the chains on either side of the pendant with 3mm rings.

At the ends, place the clasp and extension chain with 3mm rings.

And there you have it! Beautiful creation!