Easy and trendy jewelry tutorial Mother-of-pearl and wire ring

Discover in this video tutorial how to make a beautiful brass wire and mother-of-pearl ring.

Here you'll learn how to make the structure with semi-rigid wire, then place the pearl with a fine wire. And to sublimate the pearl, you can glue on a 24K gold-plated piece.

For this creation, you will need:
0.7mm semi-rigid brass wire flexible 0.4mm brass wire a flat mother-of-pearl drop pearl a glue-on pendant Uhu glue

Here are some explanations:

This jewel is very simple to make, as we're going to form a double ring from brass wire. The only difficulty will be making the loops the right size.

To do this, form 2 loops with the semi-rigid brass wire, then adjust the diameter of the loops to suit your size.

Wrap one of the wires around the loops as shown in the video to secure the structure. Do the same with the other wire in symmetry. Trim off any excess wire.

Next, wind the 0.4mm wire onto the structure and thread on the mother-of-pearl bead. Secure it by fastening the wire to the structure.

Finally, glue the piece to the bead, taking care not to apply too much glue.

A very simple tutorial suitable for beginners and experienced designers alike.

Watch the video below to guide you through the assembly process.

Beautiful creation!