This creation isn't very complicated, just follow the instructions below to make sure you get it right.

To begin, cut 2 pieces of chain, keeping 6 ball links. Then take the brass wire and form a coiled loop by placing one of the chains before coiling the wire. Cut the brass wire cleanly and, if necessary, flatten it slightly to prevent it from snagging.

Thread the 3 Lapis Lazuli beads onto the brass wire and form a symmetrical loop. Remember to place the other chain before winding the brass wire!

Your first row of bracelets is now assembled!

Now thread a crush pearl onto the silk thread, pass the needle through the last link of the chain and then back through the crush pearl. Bring it back to the last link and gently flatten it. Tie a double knot with the silk threads at the edge of the bead to be crushed, then cut the excess thread flush.

To secure the knot, you can apply a small dab of glue.

Now thread the mother-of-pearl beads, approx. 22 beads. Thread Lapis Lazuli beads through the second hole, then continue threading the mother-of-pearl beads symmetrically.

Now thread a crush bead through the last link of the chain, then back through the crush bead. Gently flatten it, taking care not to create too much tension between the beads. Your threading should remain supple!

Tie a knot between the last mother-of-pearl bead and the bead to be crushed, then secure with a small dab of glue.

Finally, connect the clasp and the extension chain (approx. 3cm) with 3mm rings.

Your jewelry is finished!

Beautiful creation!