This creation is very easy to make.

To do this, start by measuring your neck circumference. For a standard choker necklace, remember to leave a little margin for comfort. Do not tighten the necklace too close to the neck, it should fall just above the collarbones.

Here we took a measurement of 40cm with the clasp.

Unroll the silk thread to the end then thread 3 mother-of-pearl beads and the thread protector. Now place the  hook clasp in the thread protector then pass the needle through the thread protector. Pull the thread to bring all the elements previously threaded to the end of the thread, keeping about 5cm.

Then make a double knot at the edge of the thread protector (without taking the 3 mother-of-pearl beads) then bring the 3 mother-of-pearl beads to the edge of the knot. Thread the needle through the 3 mother-of-pearl beads then make a double knot. This will secure your assembly.

Place a dot of glue on the knot then cut off the excess thread.

Now start stringing the beads.

Here we give you the threading done for a 40cm necklace: Thread 25 mother-of-pearl beads, a gold washer, 8 mother-of-pearl beads, a washer, 5 mother-of-pearl beads, a washer, 5 mother-of-pearl beads, a washer, 4 mother-of-pearl beads, a washer, 3 mother-of-pearl beads, a washer, 2 mother-of-pearl beads, a washer, a mother-of-pearl, a washer. You are in the center of the necklace, go back in the other direction with a mother-of-pearl bead, a washer, 2 mother-of-pearl beads...

At the end, directly thread the 3 mother-of-pearl beads, the thread protector and the hook. Make a double knot at the edge of the thread protector, making sure to keep the assembly flexible. Then thread the needle through the 3 mother-of-pearl beads. Make a double knot then place a small dot of glue before cutting the excess thread.

Your jewel is finished!

Beautiful creation!