A tangled circles pendant
3 cabochon stones 4mm (Labradorite, Mother of Pearl, Amethyst)
Glue
3mm rings
From the chain
A lobster clasp
From the extension chain

To begin, position the stones in the desired locations. Make sure to place them in areas large enough to have a good  held under the stones.

Once the places are selected, place a small dab of glue then gently apply the cabochon. Do the same for the other stones then wait for it to dry completely.

Then cut a piece of chain of about 50cm. Ideal size for this type of pendant, it will fall just above the chest. Of course adapt this measurement to your body shape.

Place a 3mm ring on the top of the pendant (ring size for a thin chain, otherwise take a larger ring) then thread the chain into the ring.

At the ends of the chain, on one side, place a lobster clasp with a 3mm ring. On the other side, place a piece of extension chain with a 3mm ring. If the chain is very thin, you can widen the links with a reamer.

And there you have it! Beautiful creation!

Find all the supplies below: