Crystal necklace

The power of stones is yours with this superb necklace with a bohemian chic look! Moonstone and crystal quartz are combined here with 24K gold...
For this achievement you need:
50cm mini diamond chain 3cm extension chain 1 10mm lobster clasp 1 4mm ring and 2 4mm oval rings 1 strand of 2mm natural stones cube beads 1 horn pendant 1 crystal quartz pearl 1 m of 0.4mm soft brass wire 0.35mm silk thread crush beads

The power of stones is yours with this superb necklace with a bohemian chic look!

Moonstone and crystal quartz are combined here with 24K gold...

For this achievement you need:

50cm mini diamond chain
3cm extension chain
1 10mm lobster clasp
1 4mm ring and 2 4mm oval rings
1 strand of 2mm natural stones
cube beads
1 horn pendant
1 crystal quartz pearl
1 m of 0.4mm soft brass wire
0.35mm silk thread
crush beads

Assembly guide:

Here we have made a necklace of 55 cm in length, but you can perfectly adapt this necklace to the length of your choice. For this you will have to either extend the string of beads or the chain.

We will first prepare the 2 chains located on the top of the necklace. To start, cut 2 pieces of small diamond link chain, each 20cm long.

Open the oval rings then place on one of the chains, the extension chain and on the other chain the clasp. Close the rings properly.

Stringing the beads:

First, start by connecting the silk thread to one of the chains. Thread a crimp bead onto the thread, then pass the needle through the last link of the chain before passing it back through the crimp bead. Make a double knot at the edge of the crimp bead then bring the crimp bead back onto the knot. Flatten the crimp bead.

Thread the gold beads and moonstone beads onto the silk thread to form a string of approximately 15 cm. Place the golden beads randomly for a more bohemian effect.

To finish the threading, place a crimp bead on the wire, pass it through the chain link and then back through the crimp bead. Pull on the wire while maintaining flexibility. Your threading should remain fluid and you should not create tension between the beads.

Make the double knot then bring the crimp bead back onto the knot before crushing it. Cut the excess thread flush.

Open a 4 mm ring for connect the horn pendant then close the ring on the pearl chain at the desired location.

Making the Crystal Quartz pendant:

Thread the brass wire into the bead then wrap it 3/4 turns around the bead.

Pass one end of the wire through the "wire turns", do the same with the other end of the wire.

Bring the wires back to the top of the bead. On one of the wires, make a loop then connect the loop to the bead string. Then wrap the wire at the edge of the loop, around itself on one turn.

Then bring the other thread to the edge of the loop and make 3/4 turns. Cut the excess thread flush.

And there you have it! Beautiful creation!