Of the  circle pendants
Of the  horns moon pendants
a 6mm crimped connector
Of the  textured connectors
Pearls  natural
3mm and 4mm rings
From the  rosary chain and/or confetti
0.4mm soft brass wire
Clasps

For  the necklace with quartz crystal stone in gravitation in the circle:

Cut a brass wire of about 30cm, then wrap one end of the wire around the edge of the closed ring for 3 turns. Cut the excess wire and tuck the edge in for a nice finish. Then insert a small bead before making 3 more turns around the edge of the ring. Your bead should be placed outside the circle.

Stretch the thread towards the center of the circle, then thread a crystal quartz bead and position it in the center of the circle.

Wrap the wire 3 times around the pearl to secure it before going back to the opposite side for 3 times around the edge of the ring.

Thread a small bead again before making 3 more turns around the edge of the ring.

Then place small beads in the desired locations on the outside of the ring with wire.

For a more dynamic look, position the small beads randomly. A disorganized fake! Don't place them symmetrically or too regularly.

Finally, connect the moon horn with a 4mm ring and on the top of the circle the textured connector with a 4mm ring.

Cut your chain to the correct length then place the clasp and extension chain at the ends.

Attach your pendant suspension to the chain with a 4mm ring.

For the rosary chain necklace:

Assemble the different elements with 4mm rings. The moon horn at the bottom, the setting, the circle pendant then the textured connector.

Cut 20cm of rosary chain and 2 pieces of single link chains to the desired length. Connect the 2 chains to the rosary with 3mm rings (or 3mm ovals).

Finally, place the clasp and the extension chain at the ends of the chains then connect the pendant suspension to the chain with a 4mm ring.

And there you have it! Beautiful creation!