Wrapping bracelet mother-of-pearl

✨ Mother-of-Pearl Wrap Bracelet - A chic and easy DIY! ✨

Looking for a bright, trendy piece of jewelry that's easy to make? Discover our new tutorial for creating a wrap bracelet around mother-of-pearl beads. A technique accessible to all, for a modern, refined look.

Using the wrapping method, delicately wind a thread around the pearls to form an elegant bracelet that will sublimate your wrist. Ideal for beginners and DIY enthusiasts alike, this jewel will add a touch of freshness to your outfits.

See step-by-step instructions below.

You'll need :
0.4mm brass wire Gilded with 24K fine gold clasp Gilded with 24K fine gold extension chain Gilded with 24K fine gold mother-of-pearl pearls

Tools to use :
jewelry-making pliers

Assembly:

To begin, cut a brass wire approximately 20cm long (adapt this length during assembly to avoid losing wire).

At one end of the wire, form a loop, insert the clasp and wind the wire around the edge of the loop. This will form a coiled loop that secures the clasp.

Thread a bead and form a loop at the edge of the bead. Don't cut the wire, just wrap it around the bead. Don't try to wind the wire too precisely, but leave an organic side that will give more dynamics and relief to your assembly.

Then wrap the wire around the edge of the first loop for 2 turns to lock the wire in place. Cut the thread flush.

Take a new thread, form a loop, insert the loop from the previous assembly and form the wrapped loop.

Insert a new bead, form a loop and wrap around the bead. Secure the assembly by wrapping the wire around the edge of the loop.

Continue until you reach wrist length.

For the last bead, thread 3cm of extension chain through the last loop.