a plant connector pendant
a 6mm cabochon
of the rosary chain
from the little nugget chain
3mm rings
from the extension chain
a 10mm lobster clasp

flat pliers
UHU glue

This  bracelet is  very easy to make.

To start, glue the stone into the cabochon holder. Apply a small amount of glue to the center of the holder and then gently place the stone.

Wait until completely dry before continuing.

Then measure your wrist and remove the value of the pendant, approximately 3cm.

Divide the measurement obtained in 2, cut the 2 chains to size.

Connect the chains to the pendant with 3mm rings.

Finally, place the lobster clasp and the extension chain at the ends of the chains with 3mm rings.

And there you have it! Beautiful Creation!