To start,  Cut 2 pieces of 1mm wire of about 30cm each and 2 Linhasita wires of about 50/60cm.

If you take a pendant with the ring perpendicular (as for the talisman connector) you will not need to place rings. For connectors with holes, place 4mm rings.

Then thread a 1mm thread and a Linhasita thread into the ring, fold the 1mm thread in 2 and bring it back to the center to become the weft thread. The Linhasita thread will allow you to make the knots on the weft thread.

Make the knots as explained in the video, with and without beads.

Finally, place the bracelet in its final position and then make a sliding knot with a new thread.

Tie knots at the ends of the weft threads then cut off the excess.

Beautiful creations ;-)