Of the  buckles for 6mm cab
Of the  6mm cabochons
Textured oval pendants
2mm beads
Of the  textured round pendants
Glue
3mm rings
0.4mm soft brass wire

To start, cut a piece of brass wire about 20cm long.

Then place glue in the BO supports and then position the cabochons. The glue will then have time to  dry while you finish the assembly!

Wrap the wire around the pendant 3 times, then cut off any excess wire.

Thread a bead, hold it in place and then pass the wire through the pendant, from below, to come back outwards. Tighten the wire well with each pass. Continue in this way with the other beads...

Here we have positioned 15 pearls per pendant.

Once the beads are in place, wrap the 3-strand wire around the pendant then cut the excess flush and on the reverse side.

Tip: Always place the pearl in its place before wrapping the wire around the pendant. This way it will fit perfectly!

Finally, open a 3mm ring then connect the different elements together.

And there you have it! Beautiful creation!