Livraison offerte en point relais à partir de 59€

Que recherchez-vous ?

Découvrez nos nombreuses créations à réaliser vous-même...

Alba earrings

Discover our new dangling earrings enhanced with pretty Keishi mother-of-pearl beads and amethyst drops.

An elegant and very modern creation that you can easily wear on any occasion!

A fairly easy tutorial to make, ideal for beginners or experienced creators.

Beautiful creation!

For this achievement you need:

ball stud earring holders Gilded with 24K fine gold
pendants set with amethyst drops Gilded with 24K fine gold
Keishi pearls
0.4mm brass wire Gilded with 24K fine gold
of the chain Gilded with 24K fine gold
3mm rings Gilded with 24K fine gold

Tools to use:

pliers for jewelry creations (round, flat and cutting)


The assembly:

This creation is quite simple to make, follow the explanations below to faithfully reproduce this model.

To begin, thread the bead onto the brass wire.

Please note that the hole in the mother-of-pearl beads is very fine and can be a little difficult to pass through. If the thread gets stuck, do not force it, take a needle and clear the hole. The brass wire is perfectly adapted to the hole size.

Form a loop on the top of the pearl and then insert the earring into the loop. Secure the loop by making 2 turns with the brass wire between the top of the pearl and the ring of the earring. Cut the excess brass wire flush.

For a beautiful result, try to make very discreet curls!

Now repeat this for the bottom of the bead, but this time insert the chain link into the loop before wrapping the wire between the bottom of the bead and the chain link. Trim the excess wire flush.

Before finalizing and cutting the chains, make the second earring in symmetry.

Once the 2 earrings are made, position them side by side to adjust the length of the chains.

As the pearls are unique and not the same size, we will correct with the length of the chains, so your jewel will be balanced.

Cut the chains to the length of your choice. Here we have chains of about 2.5cm.

Finally, open a 3mm ring and connect the set pendant to the bottom of the chain.

Do the same for the other earring in symmetry.

Your jewel is finished!

Beautiful creation!




BO 3.8mm ball studs with 24K fine gold-plated brass ring, Premium pair €3.30 EUR
10 butterfly clasps for BO in premium 24K fine gold-plated brass €1.80 EUR
Irregular Baroque Keshi pearl elongated in natural mother-of-pearl €6.00 EUR
Soft brass wire 0.4mm in 24K fine gold-plated brass per 1 meter Premium coupon €1.00 EUR
50cm of fine Forçat link chain welded in brass gilded with fine 24K Premium gold €4.80 EUR
Pendant set with Amethyst drop in brass Gilded with fine 24K Premium gold €3.20 EUR
Pink cutting pliers for jewelry creation €5.95 EUR
Pink curved flat pliers for jewelry creation €5.95 EUR
Pink Flat Pliers for Jewelry creation €5.95 EUR
Pink round tip pliers for jewelry creation €5.95 EUR
Pendant set with Obsidian drop in brass Gilded with fine 24K Premium gold €2.80 EUR
Red Jasper drop-set pendant in brass Gilded with fine 24K Premium gold €2.80 EUR
Green Jasper drop-set pendant in brass Gilded with 24K Premium fine gold €2.80 EUR
Green Onyx drop-set pendant in brass Gilded with fine 24K Premium gold €2.60 EUR
Feldspar Moonstone drop-set pendant in brass Gilded with fine 24K Premium gold €2.80 EUR