To begin, choose your beads and pendants. Here, I chose small pendants to enhance the cascade of beads. For the Amazonite version, I opted for a shuttle pendant to extend the cascade.

Arrange your beads flat, trying to position the largest at the top and the smallest towards the bottom of the assembly. Play with the different irregular shapes to create a natural and organic look.

Cut a brass wire about 50cm long. Form a first wrapped loop, making sure to place the pendant in the loop before closing it. For a beautiful finish, I make 2 turns of wire for each loop and then cut the wire flush on the back.

To create discreet curls, use the thinner end of the round pliers!

Now thread the first bead onto the wire and make a loop around the top of the bead. Cut the wire flush and flatten the cut of the wire slightly to prevent it from snagging.

Make a new wrapped loop on the wire, incorporating your previous cast-on before wrapping the wire.

Thread the bead then make the loop on the top.

Continue the assembly until you create a pretty rosary chain of 5 beads.

Finally, after making the last loop on top of the 5th bead, thread the earring hook through the loop. Secure the assembly by tightening the earring hook.

Repeat for the second loop.

Your jewelry is finished!

Beautiful creation!