Calanque loops

Let yourself be enchanted by our new curls...

Mother-of-pearl and textured gold warmed by the sun's rays!

For this achievement you need:
of the BO supports mother-of-pearl pearls 2 24K gold spinning top beads 0.4mm brass wire or copper wire

Step 1:

To make these BO you have 2 assembly possibilities. With brass wire or copper wire but each assembly will be different. Here are the explanations...

With the brass wire:

To begin, cut a piece of wire about 20cm then form a loop at one end.

Then thread the beads onto the wire.

Once the beads are threaded, cut the wire, keeping about 8mm, then form a loop at the end of the wire.

Open the ring on the back of the earring and insert the 2 loops. Close the ring. The pearls will naturally position themselves in a drop shape.

With copper wire:

Cut a piece of wire then wrap the end of the wire directly onto the BO ring. (about 3 passes through the ring) Cut off the excess for a clean finish.

Thread the beads and then wrap the end of the wire around the ring to place the beads in a teardrop shape. Cut off the excess wire.

And there you have it! Beautiful creation!

In both versions, be careful when handling the wires, do not crush the wires too much with the pliers or they may break.

Country