From the chain
A clasp
Pearls to choose from
Pendants
3mm and 5mm rings
Of wire
Crush beads

For this tutorial you can use different threads. Cable thread, elastic thread, silk thread, nylon thread, polyester thread... and even brass wire if you want a rigid rush effect.

To start, cut a nylon thread of about 40cm. If you are using a thin thread, pass it through a needle to make threading easier.

Thread 3 beads then a crimp bead, pass through the clasp ring then pass through the crimp bead and the 3 beads again. Pull on the wire to position the beads well at the edge of the clasp. Adjust the wire so that the end reaches the edge of the last bead then flatten the crimp bead with flat pliers.

Continue stringing the beads as desired...

If you are placing pendants, first mount them on 3mm rings which you will thread between 2 beads.

Once you have the correct length of beads, thread a crimp bead again and then pass it through the chain link.

Pass it back through the crimp bead and then through 3 beads. Pull on the wire, your assembly will naturally tighten.

Be careful, your row of pearls must remain flexible but not loose. You should not see the pearls moving on the wire.

Next, flatten the crimp bead and cut the excess wire flush with the beads.

If you want to have an additional pendant on the clasp. Mount the pendant on a 5mm ring. You can then change the pendant as you wish!

Finally, measure the bracelet and your wrist then cut off the excess chain.

And there you have it! Beautiful creation!

The trick: Play with the different beads and pendants to create different versions of this bracelet and match them with all your outfits!