a faceted chain gilded with 24K fine gold
an 8mm cushion pearl in natural stone
pearls mounted in natural stone gilded with 24K fine gold
2 metal beads gilded with 24K fine gold
A eye nail gilded with 24K fine gold
rings 3mm gilded with 24K fine gold
an extension chain or a clasp attachment gilded with 24K fine gold
a lobster clasp gilded with 24K fine gold
Pliers for jewelry making

This jewel is very simple to make, to do this, thread in order, a metal bead, 6 mounted beads, the cushion bead, 6 mounted beads and a metal bead on an eye stud.

Form a simple loop similar to the one on the nail, making sure to tighten the beads on the nail so that the mounted beads are placed in a cluster. Try to make the loop as discreet as possible to give an elegant finish to your creation.

Then measure your wrist and remove the value from the previous assembly. Divide the measurement by 2. This will give you the measurement of the 2 chains that will be mounted on each side of the bracelet.

Now cut 2 faceted link chains to size.

Connect the chains on each side of the pearl stud directly to the stud loops. Open them into a spiral using flat pliers so as not to distort the roundness of the loops.

Then close the loops in the opposite direction to secure the chains. Make sure there are no gaps between the loops to prevent a chain from escaping!

Finally, place the clasp and 3cm of extension chain (or the clasp attachment) at the ends of the chains with 3mm rings.

And there you have it! Beautiful achievement!