This creation is quite simple to make; follow the explanations below to faithfully reproduce this model.

To begin, thread the bead onto the brass wire.

Please note that the hole in the mother-of-pearl beads is very fine and can be a little difficult to pass through. If the thread gets stuck, do not force it; take a needle and clear the hole. The brass wire is perfectly adapted to the hole size.

Form a loop on the top of the pearl and then insert the earring into the loop. Secure the loop by making 2 turns with the brass wire between the top of the pearl and the ring of the earring. Cut the excess brass wire flush.

For a beautiful result, try to make very subtle curls!

Now repeat this for the bottom of the bead, but this time insert the chain link into the loop before wrapping the wire between the bottom of the bead and the chain link. Trim the excess wire flush.

Before finalizing and cutting the chains, create the second earring to match.

Once the 2 earrings are made, place them side by side to adjust the chain length.

As the pearls are unique and not the same size, we will correct with the length of the chains, so your jewel will be balanced.

Cut the chains to your desired length. Here, we're using chains that are approximately 2.5cm long.

Finally, open a 3mm jump ring and connect the pendant to the bottom of the chain.

Repeat the same steps for the other earring, ensuring symmetry.

Your jewel is finished!

Beautiful creation!