Janis necklace

Here is the jewel that will never leave you! Modular and infinitely adaptable, this creation is adorned with a graphic chain on which you can hang a talisman stone, thread a pearl... And a pearly mother-of-pearl part to detach to dress up your wrist in the blink of an eye...
For this achievement you need:
Of the natural stone beads and pendants 0.4mm soft brass wire Of the chain Of the clasps and rings Nylon thread Crush beads Miyuki beads Mother of pearl pearls

Here is the jewel that will never leave you!

Modular and infinitely adaptable, this creation is adorned with a graphic chain on which you can hang a talisman stone, thread a pearl... And a pearly mother-of-pearl part to detach to dress up your wrist in the blink of an eye...

For this achievement you need:

Of the natural stone beads and pendants
0.4mm soft brass wire
Of the chain
Of the clasps and rings
Nylon thread
Crush beads
Miyuki beads
Mother of pearl pearls

Assembly guide:

To start, measure your wrist. This will be the basis for all your measurements, chain and bead threading.

For the chain part, you can wear it as a necklace with all the elements connected or as a double-wrap bracelet.

So multiply your wrist measurement by 2 and cut the chain to size.

On one side, place the clasp with a 3mm ring. Then thread the donut bead before placing the second clasp on the other end.

Then open an 8mm (or 6mm) ring and connect the heart pendant. This can be placed directly in the clasp, added or removed as you wish.

For the pearl part...

Cut a nylon thread of about 30cm. Thread a crimp bead then the clasp before passing it back through the crimp bead. Place the elements at one end of the wire, keeping about 2cm.

Flatten the pearl with flat pliers. The small end of the wire will be tucked into the pearls, to prevent it from pricking you!

Then thread the mother-of-pearl beads, altering them with small Miyuki beads.

Continue up to your wrist size.

Finally, place a crimp bead, the other part of the clasp before passing through the crimp bead and about 2cm of beads.

Pull the wire, making sure to keep some flexibility in the beads. Then flatten the crimp bead.

Finally you can create a natural stone pendant.

Choose your stone, a rough stone, a point...

Cut a 0.4mm flexible brass wire of about 20cm.

If your stone is drilled, pass the wire through the hole, otherwise you can wrap the wire directly around it.

For safety, if your stone is smooth and without holes, you can place a small dot of glue under the passages of the brass wire.

Then wrap the wire 2/3 turns, your two ends of wire meet towards the top of the stone.

With the first wire, make a "wrapped" loop then wrap the remaining wire around itself (making sure to take some with the 2nd wire.) Cut flush then wrap the 2nd wire, 2 turns to block it, then cut flush.

And there you have it! Beautiful creation!