This  This jewel is very simple to make, to do this start by assembling the center of the bracelet with the pebble connectors.

Open 4 rings 4mm and insert 3 beads mounted by rings. Close the rings correctly.

Open a 5mm ring and insert in order, a mounted pearl ring, a pebble connector, a ring of mounted pearls and the next pebble. Close the ring properly, taking care to pay attention to the pebbles. Handle them carefully so as not to damage them.

Do the same to fix the other mounted beads and the third pebble.

Measure your wrist and remove 3.4cm (value of the previous assembly with the jump rings). Divide the measurement in 2.

Then cut 2 pieces of nugget chain.

Connect the chains on each side of the roller assembly with 4mm rings.

Finally, cut an extension chain of about 3cm.

At the ends of the nugget chains, connect the clasp and the extension chain with 3mm rings.

Below you will find the flat assembly to guide you in assembling the different elements.

And there you have it! Beautiful achievement!