| An elegant touch on your wrist... This bracelet combines 24K gold and the iridescent hues of black mother-of-pearl. A very delicate creation, very easy to make, which you can personalize with the stones of your choice!
|
|---|
| For this creation, you will need: | ||||
|
| ||||
| Tools you might need: | ||||
|
| ||||
| Step 1: | ||||
| This bracelet uses classic assembly techniques. To start, glue the stone into the cabochon holder. Apply a small amount of glue to the center of the holder and then gently place the stone. Wait until completely dry before continuing. Then measure your wrist and remove the value of the pendant, which is about 2.5cm. Take the measurement tightly to the wrist, the value of the connecting rings and the carabiner will add the value of ease necessary for comfort. Divide the measurement obtained in 2, cut the 2 chains to size. Separate the chevron chains carefully by opening the chevron links using 2 flat pliers as for a ring. Then close the chevron link so that it returns to its initial position. Connect the chains to the pendant with 3mm jump rings. Be sure to pay attention to the direction of the chain. Take a good look at the photo below.
Finally, place the lobster clasp and the extension chain at the ends of the chains with 3mm rings. And there you have it! Beautiful Creation! | ||||
Join Perles Corner to discover our new arrivals, exclusive tutorials, and many other surprises... and receive your voucher by email!
a connector pendant for 8mm cabochon
3mm rings
