a bangle bracelet holder
a 4mm natural stone cabochon
Linhasita 0.5mm wire
Jewelry glue

Make the first knot:

To start, cut a Linhasita wire of about 50cm. Fold it in 2 and pass the loop under the bracelet, first to the left.

Then pass the cord located at the bottom over the cord at the top to lock it.

Then pass the cord that was at the top over the bracelet and tuck it into the loop.

Pull on both threads at the same time to tighten the knot properly and keep approximately the same length on each side.

Make the second knot:

Pass the right cord under the bracelet to create a loop on the right.

Then pass the cord located at the bottom over the cord at the top.

Then pass the cord which was up over the bracelet to fit into the buckle.

Pull on the 2 threads to tighten the knot.

Be careful to have regular knots along the entire length. Do not tighten the knots too much!

Make about 22 knots, alternating the loops each time. Right then left then right...

Then tighten the last knot well and cut the remaining threads to about 2mm.

Using a wire burner or lighter, gently burn the wires so that they melt and stick to the last knot. Press with your finger to stick the knot.

Do the same in symmetry on the other side of the bracelet...

To finish, place a little glue on the back of the cabochon.

Using flat pliers, position the cabochon on the round plate of the bracelet.

Allow to dry properly before handling the bracelet.

And there you have it! Beautiful creations!