To begin, cut a nylon thread about 80cm long (be sure to use a long enough thread, as no joints will be possible during assembly).

Thread the needle and place 12 15/0 seed beads on the thread. Pass the needle back through the first bead to form a circle of beads.

Place the circle of beads around the cabochon support.

Now work your way through all the beads in the circle to come out where the first thread exits. Tighten your assembly and then tie a double knot.

Throughout the assembly process, make sure your thread is not too loose or the petals will be too soft.

Now start assembling the beads petals.

String 9 natural stone beads (2mm) on the thread.

Then go back to the bead in the circle and the next one.

Repeat the previous step to make all the petals corresponding to the beads in the first hoop.

Once all the beads petals have been made, make a double knot with the starting thread, then pass the thread through a few beads in the first circle of pearls. Cut flush. Do the same with the starter thread.

To finish, place a small dab of glue in the base and position the cabochon. 

Your jewellery is finished!

Beautiful creation!