6mm, 8mm and 10mm bohemian beads
 du fil linhasita 0,5mm
 8mm closed rings
 a screw-on clasp

To begin, cut a linhasita thread about 60cm long.

To connect the wire to the clasp, make a series of 3 knots with the end of the wire on an 8mm closed ring. Then cut off the excess and burn the small piece of wire to secure the knot.

String the beads, starting with 6mm beads, 8mm beads and 10mm beads in the centre. Then start again in symmetry to finish threading.

Thread the 8mm ring and make a series of 3 knots at the edge of the ring.

Be careful to maintain fluidity between the beads, so before tying the knots, place the necklace in a curve. A necklace that's too rigid won't be pleasant to wear!

Finally, place the screw clasp to connect the closed rings.

And voilà! Beautiful creation!