This creation is very easy to make. 

To do this, start by measuring your neck circumference. For a standard choker necklace, remember to leave a small comfort margin. Do not tighten the necklace too close to the neck; it should fall just above the collarbones.

Here we took a measurement of 40cm with the clasp.

Unroll the silk thread to the end then thread 3 mother-of-pearl beads and the thread protector. Now place the hook clasp in the thread protector then pass the needle through the thread protector. Pull the thread to bring all the previously threaded elements to the end of the thread, keeping about 5cm. 

Then make a double knot at the edge of the thread protector (without including the 3 mother-of-pearl beads) then bring the 3 mother-of-pearl beads to the edge of the knot. Thread the needle through the 3 mother-of-pearl beads then make a double knot. This will secure your assembly.

Place a drop of glue on the knot then cut the excess thread.

Now start threading the beads.

Here we give you the threading done for a 40cm necklace: Thread 25 mother-of-pearl beads, a golden spacer, 8 mother-of-pearl beads, a spacer, 5 mother-of-pearl beads, a spacer, 5 mother-of-pearl beads, a spacer, 4 mother-of-pearl beads, a spacer, 3 mother-of-pearl beads, a spacer, 2 mother-of-pearl beads, a spacer, one mother-of-pearl bead, a spacer. You are at the center of the necklace, start again in the other direction with a mother-of-pearl bead, a spacer, 2 mother-of-pearl beads...

At the end, directly thread the 3 mother-of-pearl beads, the thread protector, and the hook. Make a double knot at the edge of the thread protector, ensuring flexibility in the assembly. Then thread the needle through the 3 mother-of-pearl beads. Make a double knot and place a small drop of glue before cutting the excess thread.

Your jewelry is finished!

Beautiful creation!