To begin, connect the 8mm closed rings to the earring holders. To do this, open the ring at the bottom of the loop and insert the closed ring. Close the ring securely with flat-nose pliers.

Now cut 3 nylon threads about 20cm long.

Connect the 3 threads to the closed ring using squeeze beads. To do this, thread a squeeze bead onto the first wire, pass the wire through the closed ring and then back through the squeeze bead. Bring the bead to be crushed towards the edge of the ring then flatten it with the flat pliers. Be careful not to squeeze the bead too close to the ring, the threading must be fluid!

Repeat the operation with the other 2 threads.

Now string the beads of your choice.

Here we've made strings of around 6 / 7cm, the longest with beads. You can either make them all the same size or, like us, play with the different lengths.

Conceal the starting threads in 3 beads, then cut the excess thread.

To finish, thread a squeeze bead onto the first wire, pass through the ring and then through the bead again and the next 3. Pull on the thread to form the loop of beads and bring the pearl to be crushed back towards the ring.

Flatten the bead to be crushed with flat tongs, taking care to leave the threading fluid.

Repeat this step with the other 2 threads.

Now repeat all the steps to create the other symmetrical loop.

Your jewellery is finished!

Beautiful creation!