Tie the nylon thread around the ring of the Zircon crimp connector. Tie several knots to make sure the thread doesn't unravel. Trim the excess wire to about 3mm from the knots.

Now string 4 seed beads 11/0 (green), a flower bead, a seed bead 11/0 (violet) and a seed bead 15/0 (salmon).

Pass the thread through all the beads except the 15/0 seed pearl (salmon). This will block the threading. 

Pass the wire through the ring on the connector and then back through the first green bead.

Now string 3 seed beads 11/0 (green), a flower beadOne 11/0 (violet) and one 15/0 (salmon).

Pass through all the beads except the small salmon pearl as before.

So you've just put together your first flower duo.

Now go back through the ring of the crimped connector. 

Repeat the previous steps to assemble the other flower stems. In all, you need to assemble 8 flowers to obtain a pretty cluster of flowers.

To finalise and secure the assembly, make several knots on the ring of the connector, taking care not to trap the thread in the flower petals or beads!

Between each assembly, remember to iron through the ring of the crimped connector. This way, your cluster will form a pretty ball.

Finally, carefully open the sleeper ring and insert the top ring of the crimped connector.

Repeat all the steps for the second loop.

Your jewellery is finished!

Beautiful creation!

Find all the supplies you need to make this jewel at the bottom of the page.