To begin, cut a brass wire about 40cm long, then insert 4 pink beads and 4 yellow beads. Place the beads, leaving about 15cm of wire at the end. 

Pull the last yellow bead aside, then pass the thread through the other strung beads. Pull on the thread to create a small row of beads blocked by the last yellow bead.

Repeat this operation to make 5 beads pistils.

Be careful to place the pistils tightly together, side by side on the brass wire. Then group the pistils into a small bunch. Join the 2 ends of the brass wire.

Insert the pistils into the centre of the flower pearl.

Now mount the flower on the connector. To do this, insert the 2 ends of the brass wire into the hole in the connector and press the flower firmly onto the connector.

Then pass the threads through the other hole in the connector, returning you to the front of the flower. 

To fix it securely, pass the threads between 2 petals of the flower to return to the first hole in the connector.

Now wind the threads between the flower and the connector around the starting threads. This will create a coiled loop. Go round again and cut the threads flush.

Now open a 4mm ring and connect the flower connector to the other identical connector.

Open a new ring and connect the previous assembly to the bottom of the earring.

Do the same for the other earring.

Your jewellery is finished!

Beautiful creation!

Find all the supplies you need to make this jewel at the bottom of the page.