6mm cab buckles
 6mm cabochons 
 Textured oval pendants
 2mm beads
 Textured round pendants
 Glue
 3mm rings
 0.4mm flexible brass wire

To begin, cut a piece of brass wire about 20cm long. 

Then place some glue in the BO supports and position the cabochons. This will give the glue time to dry before you finish!

Wrap the thread around the pendant in 3 turns, then cut off any excess thread.

Thread a pearl, hold it in place and then pass the thread through the pendant, from the underside, to the outside. Tighten the thread each time. Continue in this way with the other beads...

Here we've placed 15 beads per pendant.

Once the beads are in place, wrap the thread 3 times around the pendant, then cut the excess off flush with the back.

Tip: Always place the pearl in its place before wrapping the thread around the pendant. That way it will fit perfectly!   

Finally, open a 3mm ring and connect the various components together. 

And voilà! Beautiful creation!