BO media
 mother-of-pearl beads
 2 beads toupies or 24K
 0.4mm brass or copper wire

To make these BOs you have 2 mounting options. With brass wire or copper wire, but each assembly will be different. Here are the explanations...

With brass wire :

To begin, cut a piece of wire about 20cm long and form a loop at one end.

Then thread the beads onto the wire.

Once the beads have been strung, cut the thread, leaving about 8mm, then form a loop at the end of the thread.

Open the ring on the back of the BO and insert the 2 loops. Close the ring. The beads will naturally position themselves in the shape of a drop.

With copper wire :

Cut a piece of thread and wind the end directly onto the BO ring. (about 3 passes through the ring) Trim the excess for a clean finish.

Thread the beads and then wrap the end of the thread around the ring to place the beads in the shape of a drop. Trim the excess thread.

And voilà! Beautiful creation!

In the 2 versions, be careful when handling the threads: don't crush them too much with the pliers or they could break.