Domed earrings
 Miyuki Délica 11/0 beads
 Brass wire
 A circle connector
 Quartz crystal beads
 4mm rings

To begin, open a 4mm ring and string 3 Miyuki beads. Place the ring around the pendant and close it securely using 2 flat clips.

Repeat this step to place 6 rings per pendant, taking care to position them symmetrically in relation to the rings on the pendant. This will create small clusters of beads.

Then cut a brass wire about 15cm long and bend it in two with round-ended pliers to form a small loop. Thread a Miyuki pearl onto the wire and twist the threads to secure the pearl in the loop.

Thread the Quartz bead onto the threads.

Using one of the threads, form a loop on the top of the pearl, thread the pendant ring through the loop and then wrap the wire around the loop for 2 turns. This will close the loop and secure it. Cut the thread flush.

With the remaining thread, fold it back towards the loop at the bottom of the Quartz bead, wind it once between the loop and the bead and then wind it back up, crossing the thread to form an X on the bead.

Finally, wind the thread between the top of the pearl and the loop. Cut the thread flush.

Then open the BO ring and connect the pendant.

And there you have it! Beautiful creation!