6 Cauris pendants
 5mm rings
 7mm cabochons
 BO holders for 7mm cabochons
 Glue

To begin, open a 5mm ring and insert 2 cowrie shell pendants. Be careful to position them in the same direction. Then close the ring properly.

Continue the cascade, open a 5mm ring and then connect a new cowrie shell to the previous cowrie shell.

 For a harmonious effect, make sure you place all the cowrie shell pendants in the same direction.

Then do the same for the 2nd earring, assembling the 3 other cowries in a cascade...

Now place a small drop of glue in the BO base. Be careful not to put too much, place the drop of glue right in the centre of the base. Once the stone is in place, the glue will spread. 

If you've applied too much glue, you can remove it with a small toothpick. It's best to remove it beforehand to avoid it spilling over onto the base and the stone.

Place the cabochon in the holder and wait a few minutes before handling the buckle.

Finally, carefully open the ring on the BO bracket and connect the cowrie shell cascade.

And there you have it! Beautiful creation!