To begin, place a small dab of glue on a support (cardboard, sheet of paper, etc.) This will help you to measure out the glue properly and avoid using too much, as this can cause smudges on the supports and stones.

Using a fine point (such as a toothpick), take a small amount of glue and place it in the centre of a cabochon holder. Place the cabochon in its holder and apply a little pressure. Adjust it so that it is well positioned.

Repeat this step for all the brackets and cabochons.

Wait until completely dry or at least 5/10 minutes.

Now open a 3mm ring using 2 flat pliers, then connect the 6mm cabochon connector at the bottom of the earring holder.

Connect the cabochon connector to the bottom of the 6mm connector and finish with the oval cabochon pendant.

Make sure that the joint rings are tightly closed. If necessary, place the assembly facing a window to check that the rings are closed properly.

Repeat all the steps to make the second earring.

Your jewellery is finished!

Beautiful creation!