To begin, cut 2 pieces of 1mm wire, each about 30cm long, and 2 Linhasita threads, each about 50/60cm long.

If you take a pendant with the ring perpendicular (as for the talisman connector) you will not need to place rings. For connectors with holes, place 4mm rings.

Then thread a 1mm thread and a Linhasita thread through the ring, fold the 1mm thread in 2 and bring it back to the centre to become the weft thread. The Linhasita thread will be used to make the knots on the weft thread.

Make the knots as explained in the video, with and without beads.

To finish, place the bracelet in its final position, then make a slip knot with a new thread.

Tie knots at the ends of the weft threads and then trim off the excess.

Beautiful creations ;-)